Announcement

Collapse
No announcement yet.

starter clucth bearings

Collapse
X
 
  • Filter
  • Time
  • Show
Clear All
new posts

    starter clucth bearings

    was looking to get new starter clutch bearings for a engine I am building , looking I seen there are 2 bearing set, set one with 1 bearing , set 2 with 2 bearings , what is best one to use ?

    #2
    I feel cheated - I think my 650 starter clutch just has a sintered bronze bushing. Anyways, what engine is this?
    1981 gs650L

    "We are all born ignorant, but you have to work hard to stay stupid" Ben Franklin

    Comment


      #3
      my bad a 82 /83 1100E

      Comment


        #4
        From what I understand, there are different bearing sizes in those years depending on what crank you have. The single bearing is 29mm ID whilst the twin bearing setup is 25mm ID. Basically you'll have the measure up what you have to order the right size.
        Current:
        Z1300A5 Locomotive (swapped my Intruder for it), GS450 Cafe Project (might never finish it....), XT500 Commuter (I know - it's a Yamaha )

        Past:
        VL1500 Intruder (swapped for Z1300), ZX9R Streetfighter (lets face it - too fast....), 1984 GSX750EF, 1984 GSX1100EF (AKA GS1150)
        And a bunch of other crap Yamahas....

        Comment

        Working...
        X