Thanks.
Announcement
Collapse
No announcement yet.
VM 29 jet kits
Collapse
X
-
rputney01
VM 29 jet kits
I've seen references to a stage 3 dj kit for the 29mm smoothbores on the forum, but it isn't referenced on their site that I can find. Is it same kit as the 26mm stock carbs?
Thanks.Tags: None
-
Similar question, may be helpful, not trying to jack your thread...
Stock GS 1000 E engine, V&H pipe and K&N pods, jetted very nicely for the elevations where I ride. How will my jetting requirements change when using VM 29s?
I know I will have to fine tune but looking for a ballpark to start with.
Life is too short to ride an L.
-
Forum LongTimerGSResource Superstar
Past Site Supporter
Super Site Supporter- Mar 2006
- 35283
- Torrance, CA
Look at this information, there is suggested starting points for jetting...
Ed
To measure is to know.
Mikuni O-ring Kits For Sale...https://www.thegsresources.com/_foru...ts#post1703182
Top Newbie Mistakes thread...http://www.thegsresources.com/_forum...d.php?t=171846
Carb rebuild tutorial...https://gsarchive.bwringer.com/mtsac...d_Tutorial.pdf
KZ750E Rebuild Thread...http://www.thegsresources.com/_forum...0-Resurrection
Comment
-
rputney01
Originally posted by tkent02 View PostSimilar question, may be helpful, not trying to jack your thread...
Stock GS 1000 E engine, V&H pipe and K&N pods, jetted very nicely for the elevations where I ride. How will my jetting requirements change when using VM 29s?
I know I will have to fine tune but looking for a ballpark to start with.
Comment
-
dig through this thread, there should be some base line 29mm info for you. if not do a search I know there are several threads about 29mm jetting on a stock 1000 motor78 GS1000 Yosh replica racer project
82 Kat 1000 Project
05 CRF450x
10 990 ADV-R The big dirt bike
P.S I don't check PM to often, email me if you need me.
Comment
Comment