Announcement

Collapse
No announcement yet.

Broken jet problems

Collapse
X
 
  • Filter
  • Time
  • Show
Clear All
new posts

    Broken jet problems

    Running a stock '76/'77 GS750. The bike was idling fine but would stall every time you touched the throttle. Tore the carbs apart and found these two little jems...



    The tips are stuck in the holes and are so far quite persistent on staying put. I have spares, but I'm worried about damaging the holes. Any suggestions?

    A

    Sorry about the big picture.

    #2
    Not jets but pilot fuel screws, the tips break off like that when they are screwed in too tight.

    It is difficult to get the tips out without doing damage to the tiny ports they fit into. Compressed air sometimes works, as does a can of spray carb cleaner with the little tube to push the tip back down towards the float bowl. I have at times been able to poke the tip out with a needle but I have also ruined a few carbs that way.
    Good luck.


    Life is too short to ride an L.

    Comment

    Working...
    X