Announcement

Collapse
No announcement yet.

How do I cap Tach opening?

Collapse
X
 
  • Filter
  • Time
  • Show
Clear All
new posts

    How do I cap Tach opening?

    I've ordered an electronic tach/speedo for my build. Now I need to figure out what to use to plug where the tach cable goes into the head on my 81 450. Any ideas would greatly appreciated.

    #2
    Small freeze plug, make a small aluminum disk to fit

    Comment


      #3
      Katanas have them so they might fit.

      Comment


        #4
        Use

        JB Weld on the old tach cable fitting. Just enough to fill the hole.

        Comment


          #5
          You can replace the tach drive in most GS models with the block-off plug Suzuki used in later (electronic tach) models. Bike Bandit part nos. 1064353 (490253-001) for the plug and 1064362 (490260-001) for the seal band (or use the band from your existing tach drive). Less than $15. These parts are listed for the 1982 GS1100S, GS300 and others.

          Comment


            #6
            Thanks guys. ChicagoBob thank you very much for the part numbers.
            Last edited by Guest; 11-09-2010, 11:19 AM.

            Comment

            Working...
            X