Does anyone have a BS32 slide hanging around you could measure the vacuum port on? The ones on my 650 have been drilled out to about .107 in. I know that Dyno Jet doesn't even have you drill them out that big.
-
-
My spare unmolested set shows sbout .087 inch for that angled hole1981 gs650L
"We are all born ignorant, but you have to work hard to stay stupid" Ben Franklin -
You don't see much problem with that??? The dyno jet drill size for the stage 3 650 #39 that is .0995, where are you getting .1562, thats bigger than the dyno jet drill for my 1100. in any case .0995 to the factory size measured by Tom at .087 is a .0125 difference, why don't do drill your main jets out .0125 and tell me how that runs.Comment
Comment