'81 GS550T ignition replica for a few euro !

still no joy , its not overheating , ive gone through and checked everything a few times . hooks up , power in all the right places .

still no spark ????

Thanks Thumper88,

you wouldn't know how to bench test the ignitor once made other than fitting to the bike ?

[Thumper88]

That is a function generator to simulate the signal from the crankshaft pickup. The software is NI Multisim.

Thats ok mate thanks anyway

[ATTACH=CONFIG]50362[/ATTACH]

Hi Guys , can some one please tell me what the xp01 circled in red is on this schematic .

Also does anyone have the file for the pcb software .

cheers

David

Just looking at it (the resolution is pretty low), it appears to be a transistor. I think a PNP type, but I can't remember which is which.

gs550 schematic.jpg

Hi Guys , can some one please tell me what the xp01 circled in red is on this schematic .

Also does anyone have the file for the pcb software .

cheers

David

Hi kokar ,

i copied all the images from your facebook, which seemed easier than joining a greecian , forum using google tranlate hehe .

ive spent the last day going through components to get equivalents for the pcb from jaycar electronics and ebay.

The hardest thing is matching the components and what is ok to uprate more and what isnt .

my limited understanding of electronics is that its ok withe the capacitors and the transistors but the resistors have to be exact.

has the ignitor proven to be more reliable than the stock one.

Also is the pcb an exact replica can the original be used if recycled ok.

cheers

David

Here's a link to a copy of the original .pdf of the Suzuki ignitor repair...

http://www.mediafire.com/download/sij2and9uh1xy6v/Repair_and_Fault_finding_GS1000G_Ignitor.pdf

I used the info in the last pages to build an HEI ignitor, with good results.

hello
this is not the same igniter

Thank you Grimly , but am looking to construct Kokar's. Anyone with the.LAY file "Laying" around

[Grimly]

Here's a link to a copy of the original .pdf of the Suzuki ignitor repair...

http://www.mediafire.com/download/sij2and9uh1xy6v/Repair_and_Fault_finding_GS1000G_Ignitor.pdf

I used the info in the last pages to build an HEI ignitor, with good results.

Hi Kokar and friends, i am sorry to have this hunt you back after all this years but i am trying to save my bike therefore attempting this project , could i get a valid access to the ".lay file also the LED schematic?"

roeme i found the stuff , thank you for the help

[roeme]

This is a well done job and very appreciated effort , i am only having trouble finding the schematic here , noon of the pictures showing , would someone kindly help me please ?

Page two of the thread he linked. http://www.moto.gr/forums/showthread...=130182&page=2


But yeah, somebody should pull that stuff and put it somewhere more accessible. Might be a worthy addition to bikecliff's pages.

This is a well done job and very appreciated effort , i am only having trouble finding the schematic here , noon of the pictures showing , would someone kindly help me please ?

Thanks, I figured out the 3rd wire was the oil sensor and no one was including that in their count, so I got a dyna s. I had to grind a semi circle out on the bottom of it to clear the oil pressure sensor. I will keep a look out for a stock igniter. I just realized the electrical wiring is looking a little rough under the seat, going to have to chase some wires. Thanks again