Search:

Type: Posts; User: Nessism; Keyword(s):

Page 1 of 20 1 2 3 4

Search: Search took 0.17 seconds.

  1. Replies
    3
    Views
    57

    Yes, they can be made to work. Before you get...

    Yes, they can be made to work.

    Before you get too far ahead of yourself please be sure the read the Newbie Mistakes thread linked in my signature. And any carbs you get should be fully rebuilt...
  2. Thread: 83 650 gl

    by Nessism
    Replies
    3
    Views
    56

    The answer can be found on page 2-10 of the...

    The answer can be found on page 2-10 of the factory Suzuki service manual for your bike...

    http://zeus.mtsac.edu/~cliff/storage/gs/GS650GManual.pdf

    62946

    FWIW: the D8EA is a smaller diameter...
  3. You might want to check the carb rebuild tutorial...

    You might want to check the carb rebuild tutorial and Newbie Mistakes thread linked in my signature. Rebuilding the carbs properly is easy, it just takes some time.
  4. Replies
    59
    Views
    1,422

    Did you wire up the system like shown in the...

    Did you wire up the system like shown in the SH775 install diagram?
  5. Replies
    3
    Views
    81

    Suzuki doesn't typically sell parts like that...

    Suzuki doesn't typically sell parts like that since it's not intended to be a service part. Your best bet is to either make a new bushing on a lathe or buy a new/used cover.
  6. Replies
    1
    Views
    61

    Did you check the part numbers using a place like...

    Did you check the part numbers using a place like partzilla?
  7. Replies
    10
    Views
    106

    The vacuum line can be left open when testing the...

    The vacuum line can be left open when testing the carbs off the bike.

    First thing I'd do is make sure the floats are not installed up side down. Yes obvious, but I've bought carbs off ebay that...
  8. Thread: Electric fault

    by Nessism
    Replies
    7
    Views
    152

    Not sure if this is related but the pre-1980 turn...

    Not sure if this is related but the pre-1980 turn signal control units were garbage and failed often. I've not heard about them causing fuses to fail before but who knows?
  9. Replies
    34
    Views
    2,950

    14.82 VDC with a SH775? That's a touch high, but...

    14.82 VDC with a SH775? That's a touch high, but not alarmingly so.
  10. Replies
    24
    Views
    333

    I'm fairly meticulous about keeping my car clean....

    I'm fairly meticulous about keeping my car clean. Mostly because I want the paint to last.

    I use Chemical Guys Mr. Pink car wash and like it. A wash mitt you can put your hand inside makes the...
  11. Replies
    10
    Views
    201

    Clean carbs per tutorial and replace O-rings. ...

    Clean carbs per tutorial and replace O-rings. Adjust valves. Review all items in the Newbie Mistakes thread and make sure you are not missing anything.

    Shortcuts are long cuts. Doing all...
  12. Replies
    9
    Views
    253

    The thumb or the bike?

    The thumb or the bike?
  13. Replies
    5
    Views
    134

    Brake cleaner won't remove corrosion. That's why...

    Brake cleaner won't remove corrosion. That's why the screws seize.
  14. Replies
    5
    Views
    134

    Heat and PB Blaster (or similar) works most of...

    Heat and PB Blaster (or similar) works most of the time. It's critical to use a screwdriver that tightly fits the slot. Custom grind a screwdriver if you have to. It may take several...
  15. Thread: Cu head gasket

    by Nessism
    Replies
    25
    Views
    851

    To avoid leaking, full stop, this is what you...

    To avoid leaking, full stop, this is what you should do: 1) check the gasket surface for flatness and surface finish on both the cylinder and head and have them faced if not perfect, 2) buy fresh OEM...
  16. Replies
    66
    Views
    1,101

    FWD is massively better in the snow than RWD. To...

    FWD is massively better in the snow than RWD. To the point where 4WD isn't needed unless you are in extreme conditions or maybe for a truck.

    FWD is more efficient because the power doesn't have...
  17. Replies
    2
    Views
    77

    Yes, the 34's can be made to work. I can't guide...

    Yes, the 34's can be made to work. I can't guide you on jetting but I'm sure it can be done. Kawasaki GPz750's used BS34's so why not a GS?

    $350 seems on the high end unless the carbs are in...
  18. Replies
    7
    Views
    143

    10.7V isn't too bad. How are you judging spark? ...

    10.7V isn't too bad. How are you judging spark? On a bright day it's hard to see a plug spark so don't assume the worst. Check in a darkened garage to properly judge.
  19. Thread: Faulty coil ?

    by Nessism
    Replies
    4
    Views
    78

    Is the charging system working and do you have a...

    Is the charging system working and do you have a good battery? The DC voltage across the battery at 5000 rpm should be in the range of 14.5 V. Are the valves properly adjusted?
  20. Replies
    20
    Views
    534

    No. 18T front and 46 or 47T rear. All in 530.

    No. 18T front and 46 or 47T rear. All in 530.
  21. Replies
    20
    Views
    534

    A 47T or 46T rear sprocket will help out with...

    A 47T or 46T rear sprocket will help out with this situation, it will also give you less rpm on the highway.
  22. Replies
    20
    Views
    534

    What goals would drive someone to want to smaller...

    What goals would drive someone to want to smaller and less efficient front sprocket?
  23. Replies
    20
    Views
    534

    Best practice is to match the front sprocket...

    Best practice is to match the front sprocket size. Never smaller.
  24. Replies
    20
    Views
    534

    This is incorrect. Pitch diameter for 630 15T...

    This is incorrect.

    Pitch diameter for 630 15T sprocket is 92mm
    Pitch diameter for 530 17T sprocket is 86mm
    Pitch diameter for 530 18T sprocket is 91mm
  25. You shouldn't need to change much if anything in...

    You shouldn't need to change much if anything in the way of jetting. It's pods that through the carbs all out of whack.
Results 1 to 25 of 500
Page 1 of 20 1 2 3 4