Search:

Thanks :encouragement:

Hi
ready to re fit the cylinder head to my GS750, the gasket set has four small o ring type seals, i remember taking the head off these were around the 4 outer studs but i don't see any reference...

not done it yet, just sorting out the valves, i do see now it just slips into the guide at the bottom, i was told to put it behind it but i never thought that would be right ,hopefully all will fall...

Thanks, yes i keep looking down with a torch wondering, you put my mind at rest :encouragement:

thanks, that's what it appears to me, just wondered if it had to be anchored somehow,
cheers

hi all
i am at the stage of re fitting the cylinder head on my GS750, the Haynes manual states to ensure the forward blade is not allowed to float as chain damage can occur, i am not 100 percent...

yes you are right, i have ordered the Suzuki parts :encouragement:

thanks Steve, sent you an email :tickled_pink:

yes, i have ordered the genuine Suzuki part :D

yes i think the US call it a wrist pin

thanks i wont use the removed ones :D

ok thanks ill order them

thanks, did you find an alternative washer for the cylinder head that has the oil feeds?, seems expensive to get genuine washers ?

Hi all.
is it advisable to renew all 8 piston circlips even if 4 have not been taken out?
thanks
Andy
8 valve gs750 1977

great thanks for the help:eagerness:

thanks for the help, your engine looks great :o

Thanks, I will do that using the sump opening

thanks, that's how i see it

Hi all.
i have sussed out the gearbox now, i have a question regarding joining the cases, the manual says to build the crankshaft and gear clusters into the top case then lower the bottom on to it,...

thanks, very interesting, i notice the 550 gears stay in the top case as apposed to the bottom on the 750, good work there thanks.

Hi
I am putting the gear selector drum and gear shafts back in, the manual is a little vague re the installation of the drum and the pawls, is there a critical way to re install the selector drum ?,...

Thanks
i will search the forum 👍

Hi all
my engine is stripped to the bare cases for a crank change so I thought I would paint them while I can, what have people used and with what results to get the best appearance to as new and a...

thanks, i don't know about the regulator yet, i just found a crack in the crankcases ,oil is leaking out so its going to be a full engine re build unless i can find a replacement somewhere :(

cheers for that :encouragement: