17 results in 0.0071 seconds.
-
GS850 Cam Followers/Tappet Bucket Won?t Install
This is driving me nuts! I had the head on my ?82 GS850 reconditioned. The shop reseated all the valves, put in new seals, planed the gasket surfaces... -
How do I tell if the cam chain needs replacing?
I am replacing the piston rings on my 78 GS1000. I have the head off and am working on getting the cylinder block off...the rear chain guide is jammed... -
shim size all over the place.....
1982 gs1100 gk.
hadn't run for the first year i owned it while i was going through it.
I checked all the valve clearances and... -
cam chain slack
Hello GS collective,
1982 GS1100 gk owner here. Have a bike that I got running after sitting for about 1.5 years. Started... -
Cam chain timing
First, thank you everyone for all the helpful information on this site! It's been a great resource getting my GS650G back to where she should be! This... -
Strangely worn camshaft
Hello,
I have just had my cylinder head on my GS450 serviced, with polishing the cams, cam shells, adjusted valves, lapped valve seats.... -
Gasket pieces fell into cam chain area!
This afternoon I took the valve cover off my 1980 850G for the first time in 20 years. The gasket was in pretty bad shape. The areas where it was leaking... -
Crazy negative compression cam?
I ebay'd a used head that came complete. (Cams, buckets, shims, everything.) After cleaning it up and installing it I got vacuum instead of compression!... -
81 GS650G Head tapping when warm
My 650 has a tapping noise in the head from what sounds like cylinder 3, but only when the engine is being restarted from a warm condition and it only... -
Checking Valve Clearances
Hi all,
Following some study on how to do this I have come across 4 different methods from credible sources. On this forum there has been... -
650G rebuilt - hit road @ Cams
After a year hiatus I'm trying to complete my rebuild of a 1982 GS650G and I'm attempting to finish the engine assembly. I'm completely rebuilding the... -
Degreeing Camshafts -- Information Required
I have the new 650 cams and sprockets on their way from the U.S. As soon as I have the valve stems ground to size and the cams arrive I will be going...Last edited by Guest; 03-03-2010, 05:14 PM. -
New tool for rotating camshaft
Sometimes it is necessary to rotate the camshaft when the chain drive is not connected up to it from the crankshaft. This happens when you are installing...Last edited by Guest; 02-25-2010, 09:46 PM. -
Can I Remove Rubber Damper on Camshaft Sprocket
I have searched and cannot find anything on this subject. Honest!!!!!!!!
On the 550 camshaft sprockets there are two rubber dampers on each...Last edited by Guest; 02-24-2010, 06:48 AM. -
valve adjustment issue
So I'm affraid to hear the responses to this, but here it goes:
I've never done a valve adjustment before, so I read up on it and found...
