1978 gs550e
I have the head off, the gasket surface is warped and is going to need at least 0.009 milled off to be flat and level.
...
14 results in 0.0066 seconds.
-
Head resurfacing, should I degree the cams?
-
Top-end reseal on an '80 GS850 question/concern
Hey all. First off, those looking for a tip on base gasket removal.... try aircraft stripper. Gasket remover didn't do much but aircraft stripper made... -
Unexpected oil leak from GS450 head
Hi All,
Running my head into a wall here?
I have finished putting together a GS450 engine and found a leak coming... -
81 gs850 valve clearance
Finally got my bike running after a carb rebuild and new intake boots. but once the bike is hot and i turn it off to restart it, it will not start back... -
How to remove head gasket residue
I removed the head gasket but I'm having a heck of a time removing the residue left behind from the head gasket. Any suggestions? -
Head Gasket Orientation: Which Side Up or Down? 450 OEM
'80 GS450, New OEM Gasket. Two sides are different, but which is which? Nothing printed on it to indicate (just some white crap on one side). Different... -
GS550/ 650 Exhaust
I tried searching forum for a clear answer, so if I missed it let me know and point me in the right direction. Otherwise, are the 550 and 650E or G/ GL... -
Time for a rebuild?
Seems over the last 1000 miles my 1982 GS1100GL bike had been losing some power and finally took the time to figure it out: cylinder #3 has only 75 PSI... -
Head Gasket Area Pitting
I'm overhauling my '80 GS450's engine. I was cleaning up the bottom of the head, and I discovered some substantial pitting in the area between the cylinders... -
GS450 Cylinder Head Replacment
Hello,
I am currently rebuilding my 1981 GS450T. I need a new cylinder head because the exhaust studs snapped off in the head and when I... -
head gasket problems
Sorry I havent posted in a while , but the mechanic has had my bike for over 3 MONTHS!!! Started out as a 2 week job has carried over to 3 months and... -
Oh boy, I did I mess up my valve adjustment.
After fiddling with the bike for about two months now, following this forum's recommendations on how to get a bike running nicely and safely. I finally... -
Gas in the oil
I have had my carbs re-done 2 times now trying to stop the gas from getting into my oil with no luck, so my next assumption would be the head gasket.... -
1981 gs850gl low compression
Trying to finish my winter project and wondering if I was sent the right head gasket. Does anyone know if there was an update on these as my old one...
