11 results in 0.0058 seconds.
-
Too many rings?
Hi everyone, I've been rebuilding my Gs250T engine for a while now, and I'm finally getting to the point where I should replace the piston rings. But...You do not have permission to view this gallery.
This gallery has 1 photos. -
impossible task of fitting rubber boot to brake caliper
Hi,
I'm having a hell of a job fitting the boot to my rear brake caliper. There is only the smallest of ridges for the boot to fit the boot... -
1982 gs750t master cylinder Rebuild or Replace?
I've finished my top end rebuild with the extra time I have with quarantine, but an engine is no good without any brakes. I took the master cylinder off... -
My GS450 -> GS500 Cylinder and Piston Swap
I've been meaning to do this for a while and have my GS450 fully disassembled right now. I have a set of GS500 cylinders, pistons and cams. Not sure if...Last edited by sam000lee; 08-13-2018, 08:03 AM. -
Compression probs
Howdy folks, new to the group and the GS world and looking for some wisdom.
I bought a 1977 GS550 that a guy had done all the hard work:... -
GS400 Front Brake Caliper Piston Size? And question?
Hey Guys,
I have a question I was I was hoping you could answer-- I recently purchased a replacement M/C brake lever unit with a 14mm... -
Snap Rings?
I'm rebuilding the engine of my 1979 gs1000 and i'm having trouble finding new piston snap rings/ retaining rings. Does anyone know where I could buy... -
The 81 GS1000 Cylinder Mystery
Greetings guys!
I've been working on my gs1000, currently combing the engine - and when I took calipers to my engine's cylinders, I discovered... -
Piston damage? Chipping/cracking?
So I'm getting better, but I'm still learning to distinguish between what is actual damage and what is an artifact of casting aluminum. Found this inside... -
8v top end swap question
will the pistons, jug, and head off an 8v 850 shafty drop into/onto my 77' 750 case?
I am talking to elevatorman71 about his parts and just... -
Removing carbon from piston tops & other places, head,etc.
I have come across this product that makes the cleaning of the carbon off the piston crowns a real breeze and saves any scratches, gouges, etc on the...
