Announcement

Collapse
No announcement yet.

Rebuild clutch basket GS1000E

Collapse
X
 
  • Filter
  • Time
  • Show
Clear All
new posts

    Rebuild clutch basket GS1000E

    Hi, I'm rebuilding a GS 1000E '80 and bought heavy duty clutch springs for the clutch basket.
    Grinding the rivets and hammered these out of the basket.

    Then it went wrong. The basket and the pieces fell on the ground when it came loose.

    There is a small curved ring beneath the backing-plate. Is this the right way to assemble? (curved up).
    And... can I re-use the basket with those grooves?

    Clutch 3.jpg
    Last edited by seabird; 01-02-2022, 05:52 AM.

    #2
    Personally, I don't remove the rivets. When the backplate goes back on, a rosette weld in the original hole works quite well.
    I don't think it greatly matters which way up that washer is - witness marks might tell you which way it has been previously.
    Yeah, all the spring recesses go like that. Reuse it.

    Comment


      #3
      Thanks Greg. I will reuse it.

      Comment

      Working...
      X