Announcement

Collapse
No announcement yet.

82 650E - Alternative/Upgrade brake options?

Collapse
X
 
  • Filter
  • Time
  • Show
Clear All
new posts

    82 650E - Alternative/Upgrade brake options?

    Hi all,

    I've been rebuilding an '82 650E that's sat for way too long, it's going well but I have a rear brake setup that's giving me issues. After dismantling the caliper, cleaning it, and changing the seals, the caliper will compress but not release when the brake lever is pressed and released. I was told that it was likely dirt in the master cylinder and so I pulled it and cleaned it out, remounted it and ran into similar issues. Since then I've pulled it all out again and done a VERY thorough cleaning/inspection, pulled apart the entire MC (can't remember if I did the full deal last time or not) and I'm ready to reassemble/remount, hopefully it works this time.

    IF this doesn't work, and I have to buy some replacement parts, I was curious about alternate setups that fit/work with our bikes? Aside from bolt holes/clearance issues can newer break setups be used on our bikes? e.g. - there's a 2007 FZR being parted out near me with brakes being offered (mc, lines, caliper pads,), if you could mount it and there was clearance are there issues using something like this? Or are there bikes that are bolt on fits? Or just aftermarket setups that are worth the upgrade?

    Thanks for any insight you guys can provide, just looking at options right now
    1982 GS650e - Cafe or Scrambler...that is the question...

    #2
    Did you make sure the tiny little fluid return hole in the master is open? That hole often plugs up and causes to brakes to not release. Also, it's critical that you change the brake lines because they are likely full of crud which will contaminate the system quickly and set you back to the beginning.
    Ed

    To measure is to know.

    Mikuni O-ring Kits For Sale...https://www.thegsresources.com/_foru...ts#post1703182

    Top Newbie Mistakes thread...http://www.thegsresources.com/_forum...d.php?t=171846

    Carb rebuild tutorial...https://gsarchive.bwringer.com/mtsac...d_Tutorial.pdf

    KZ750E Rebuild Thread...http://www.thegsresources.com/_forum...0-Resurrection

    Comment


      #3
      Originally posted by Nessism View Post
      Did you make sure the tiny little fluid return hole in the master is open? That hole often plugs up and causes to brakes to not release. Also, it's critical that you change the brake lines because they are likely full of crud which will contaminate the system quickly and set you back to the beginning.
      Yes, I made a point to look at that hole, you’re right it’s tiny.

      Also, I put on new lines braided lines front & back
      1982 GS650e - Cafe or Scrambler...that is the question...

      Comment


        #4
        If you can’t save your existing master cylinder....there’s a few that would work as direct swap

        1981 gs650L

        "We are all born ignorant, but you have to work hard to stay stupid" Ben Franklin

        Comment


          #5
          Also, check out Salty Monk's upgrade here - https://www.thegsresources.com/_foru...hlight=twinpot
          sigpic
          Cowboy Up or Quit. - Run Free Lou and Rest in Peace

          1981 GS550T - My First
          1981 GS550L - My Eldest Daughter's
          2007 GSF1250SA Bandit - My touring bike

          Sit tall in the saddle Hold your head up high
          Keep your eyes fixed where the trail meets the sky and live like you ain't afraid to die
          and don't be scared, just enjoy your ride - Chris Ledoux, "The Ride"

          Comment


            #6
            I cleaned all the parts and remounted them this weekend, but haven't had a chance to properly test them yet, Hopefully soon.

            Originally posted by cowboyup3371 View Post
            Also, check out Salty Monk's upgrade here - https://www.thegsresources.com/_foru...hlight=twinpot
            Will do, have it open now

            I'll keep those in mind when/if I'm part surfing.

            Are there other, modern bikes that have swappable systems? (even if you have to fab up a mounting bracket?)

            Thanks for all the feedback folks!
            1982 GS650e - Cafe or Scrambler...that is the question...

            Comment

            Working...
            X