• Required reading for all forum users!!!

    Welcome!
    Register to access the full functionality of the GSResources forum. Until you register and activate your account you will not have full forum access, nor will you be able to post or reply to messages.

    A note to new registrants...
    All new forum registrations must be activated via email before you have full access to the forum.

    A Special Note about Email accounts!
    DO NOT SIGN UP USING hotmail, outlook, gmx, sbcglobal, att, bellsouth or email.com. They delete our forum signup emails.

    A note to old forum members...
    I receive numerous requests from people who can no longer log in because their accounts were deleted. As mentioned in the forum FAQ, user accounts are deleted if you haven't logged in for the past 6 months. If you can't log in, then create a new forum account. If you don't get an error message, then check your email account for an activation message. If you get a message stating that the email address is already in use, then your account still exists so follow the instructions in the forum FAQ for resetting your password.

    Have you forgotten your password or have a new email address? Then read the forum FAQ for details on how to reset it.

    Any email requests for "can't log in anymore" problems or "lost my password" problems will be deleted. Read the forum FAQ and follow the instructions there - that's what we have one for...

  • Returning Visitors

    If you are a returning visitor who never received your confirmation email, then odds are your email provider is blockinig emails from our server. The only thing that can be done to get around this is you will have to try creating another forum account using an email address from another domain.

    If you are a returning visitor to the forum and can't log in using your old forum name and password but used to be able to then chances are your account is deleted. Purges of the databases are done regularly. You will have to create a new forum account and you should be all set.

Fork Seal - BackUp Washer - Dust Wiper

Redman

Redman

Forum Guru
Super Site Supporter
Past Site Supporter
Instructions show 5 parts, and kit has 3 parts..... had me puzzled for a bit.

IMG_8644cmt_h800_zps9pbbfnno.jpg


THe parts On the instructions
1 Dust wiper
I think that is the hard plastic big part.

2 snap ring
I gather that is to be reused from existing

3 BackUp Washer

4 Seal.
THe rubber part.
I gather the instructions are saying for the smooth flat edge to be on top.
And the open / finned edge on bottom.
It does not seem to be tapered as shown on sketch.

5 Original Washer.
I gather this is to be the exisitng installed one, if any.

Does it seem that I have the parts in the right order / orientation ..?

PS: I think I will also be getting a driver tool (41mm for GK).
 
Redman said:
PS: I think I will also be getting a driver tool (41mm for GK).
Click to expand...
See if you have some PVC pipe available in short lengths. Maybe ACE Hardware?

A two-foot section of 1 1/2" (internal diameter) pipe will do perfectly.

Cut a slit along the entire length, it will expand to fit your tubes

That will give you a full circle of even banging power at a fraction of the cost of a driver.

.
 
You must log in or register to reply here.
Back
Top