GS750D/E tool for removing flywheel 09930-33710

[jtolletje]

Hello,

I am restoring a GS750D/E and need to remove the flywheel to correct the starter clutch problem. To do this i need the Suzuki tool 09930-33710 to attach the slide hammer. Does somebody have this for sale?

Alternative would be a common bold that i can modify. But i need to know what size bolt and thread.

John Tolhuisen form the Netherlands.

[Rich82GS750TZ]

I read once (or dreamed it- not sure) that the rear axle threaded end is the same thread and pitch. I could be really wrong. Can anyone verify?

Oh, I I see you just snuck your first post in with a question.

Welcome to the forum.

Make an introductory post in the GS Owners Forum. Tell us about yourself and more importantly, you bike(s). And we like pictures.

[tom203]

Remove the bolt that’s holding the rotor on……then determine the female thread inside the rotor….get a bolt to fit and drive rotor off crankshaft…an electric impact wrench comes in handy !
on my 650..this bolt would be 16 x 1.5 mm

some rotors have an external thread on rotor hub …fancy tool required.like in pic