My 83' GS750ES has been delivered

[650Skull]

Its not so much the jets and that are the problem when dipping carbs without dismantling............its the rubber that gets damaged. Mainly the throttle shaft seals so the carbs need to be completely dismantled if dipping...........

[grcamna2]

Its not so much the jets and that are the problem when dipping carbs without dismantling............its the rubber that gets damaged. Mainly the throttle shaft seals so the carbs need to be completely dismantled if dipping...........

Hi,thanks.I appreciate your feedback.

[grcamna2]

You can lead a horse to water, ...

You must be getting dehydrated in the doghouse;make sure you ask your master for some fresh water soon.

[1948man]

I have used a "bristle" from a wire brush for clogs and with a little help from a can of oil spray equipped with a long plastic "nozzle" it poked and blew its its way through easily.

Yep, that's the generally approved way after dipping. I use ultrasonic instead of 24 hr dipping but can't swear it's as good.

[trevor]

Is there still no pictures of this bike??

[rphillips]

Pictures on post # 23, 24, & 25. Pictures look good

[grcamna2]

Well,Ok,
I've been 'on hold' as my main focus has been to locate parts,specifically an OEM stock exhaust system for my 750ES.
I've been scouring the sites and just yesterday I found the needed pipes on Ebay:I had to order them from 2 separate sellers,one from AL. and the other from Kenosha,WI.I expect it'll be about a week before they come in which will give me a bit more time to do a few things in the early morning(7-10:30AM)hours when it's cooler outside;I just need to get to sleep early enough to overcome this serious sleep deprivation I've had ever since I've lived on the top floor,on the corner of this very busy commercial section of Davis.I'm more of a 'night owl' but I'll need to change that because the traffic is Very Loud.

The #2/#3 center pipe section has a very(almost rusted all the way through)rusty lower balance connector down the bottom and will need to be brought over to the 'old time' welder I just found in the last few months.I hope he's able to 'shore it up' sufficiently so I'm good to go for the life of the bike.

[trevor]

Well,Ok,
I've been 'on hold' as my main focus has been to locate parts,specifically an OEM stock exhaust system for my 750ES.
I've been scouring the sites and just yesterday I found the needed pipes on Ebay:I had to order them from 2 separate sellers,one from AL. and the other from Kenosha,WI.I expect it'll be about a week before they come in which will give me a bit more time to do a few things in the early morning(7-10:30AM)hours when it's cooler outside;I just need to get to sleep early enough to overcome this serious sleep deprivation I've had ever since I've lived on the top floor,on the corner of this very busy commercial section of Davis.I'm more of a 'night owl' but I'll need to change that because the traffic is Very Loud.

The #2/#3 center pipe section has a very(almost rusted all the way through)rusty lower balance connector down the bottom and will need to be brought over to the 'old time' welder I just found in the last few months.I hope he's able to 'shore it up' sufficiently so I'm good to go for the life of the bike.

Not getting sleep sucks...do you work shift work?

[grcamna2]

Not getting sleep sucks...do you work shift work?

No,I just like staying up late,it's a habit from the past,plus eating too late in the evening then staring at the computer into the night.I'm going to need to start some new habits: #1 getting to sleep earlier.
My entire week works better for me when I get more than 4-5hrs. sleep in consecutive nights..

[trevor]

No,I just like staying up late,it's a habit from the past,plus eating too late in the evening then staring at the computer into the night.I'm going to need to start some new habits: #1 getting to sleep earlier.
My entire week works better for me when I get more than 4-5hrs. sleep in consecutive nights..

Wow...what time do you have to get up for work?

[grcamna2]

Wow...what time do you have to get up for work?

This seems to me like we have a misunderstanding.
I was speaking about sleep deprivation and you're speaking about work.

Trevor,what is your work ?

[storm 64]

This seems to me like we have a misunderstanding.
I was speaking about sleep deprivation and you're speaking about work.

Trevor,what is your work ?

I think he details motorcycles... read "My New Gig" 😉

[trevor]

I think he details motorcycles... read "My New Gig" 

Lol....yes...it's my new part time job on top of my full time job...motorcycles are expensive.

[grcamna2]

Trevor,I took a look at your thread and noticed the bikes.

[trevor]

Trevor,I took a look at your thread and noticed the bikes.

Ohhhh...kaaaaayyy.....