.png "Powered by vBulletin")
Years ago an engine fell over and luck would have it whatever it hit pushed the sight glass out. So my question is for those that have installed one what's the process. I was for sure planning on some three bond around it when reinserting it.
-
MY BIKES..1977 GS 750 B, 1978 GS 1000 C (X2)
1978 GS 1000 E, 1979 GS 1000 S, 1973 Yamaha TX 750, 1977 Kawasaki KZ 650B1, 1975 Honda GL1000 Goldwing, 1983 CB 650SC Nighthawk, 1972 Honda CB 350K4, 74 Honda CB550
NEVER SNEAK UP ON A SLEEPING DOG..NOT EVEN YOUR OWN.
I would rather trust my bike to a "QUACK" that KNOWS how to fix it rather than a book worm that THINKS HE KNOWS how to fix it. -
A look at a spare cover shows a generous amount of adhesive.
they are like brake res sight glasses.
Is there any solvent that will melt ages old sealant?1983 GS 550 LD
2009 BMW K1300s -
I have replaced one, make sure hole in case is nice and clean. I used scotchbright, very thin smear of threebond in hole and around sight glass rubber. Ease in with your thumb, wipe any excess sealer off with solvent and leave to set.My bikes 79 GS1000 1085 checked and approved by stator the GSR mascot :eagerness: and 77 GS750 with 850 top end, GS850g, and my eldest sons 78 GS550, youngest sons GS125. Project bike 79 GS1000NComment
Comment