Hi, on my '81 GS850G, finally getting engine back together, but found 2 washer/seals on the lift & don't remember where they came from. (I can send image to an email address but don't know how to post images to the site.)
These seals resemble exactly in appearance & size the ones built into the 4 corners of the new Suzuki head gasket I just installed but the old ones I found are loose and do not appear to have been pulled from old head gasket.
Also there were 4 built into the gasket and I have only found 2 on the lift. I cannot find the old head gasket to see if they had these seals built in or not as that was pulled back in the fall and my memory is useless to recall.
Seals are metal with rubber attached to inner opening. About 20mm OD & 12+MM ID.
I have a pic or two in my dig cam I can send to you or post if given help how to do that.
Thank you for your help, hope I don't have to tear down the head/barrel again.
DH
These seals resemble exactly in appearance & size the ones built into the 4 corners of the new Suzuki head gasket I just installed but the old ones I found are loose and do not appear to have been pulled from old head gasket.
Also there were 4 built into the gasket and I have only found 2 on the lift. I cannot find the old head gasket to see if they had these seals built in or not as that was pulled back in the fall and my memory is useless to recall.
Seals are metal with rubber attached to inner opening. About 20mm OD & 12+MM ID.
I have a pic or two in my dig cam I can send to you or post if given help how to do that.
Thank you for your help, hope I don't have to tear down the head/barrel again.
DH
Comment