Cam position

Collapse
X
 
  • Time
  • Show
Clear All
new posts
  • stain
    • Feb 2026

    #1

    Cam position

    I was changing the cam gears on my 1000 when I got distracted AFTER I pulled my gears off. Came back to reinstall my gears and can't remember if the at TDC 1-4 if the slots at the end of the cams are facing inward or outward. Dont want to install my cams 180 off!!!
    I feel like a tool.
  • Nessism
    Forum LongTimer
    GSResource Superstar
    Past Site Supporter
    Super Site Supporter
    • Mar 2006
    • 35790
    • Torrance, CA

    #2
    Inward, pointing at each other. You should not use these marks to time the cams though, that's what the marks on the cam sprockets are for.
    Ed

    To measure is to know.

    Mikuni O-ring Kits For Sale...https://www.thegsresources.com/_foru...ts#post1703182

    Top Newbie Mistakes thread...http://www.thegsresources.com/_forum...d.php?t=171846

    Carb rebuild tutorial...https://gsarchive.bwringer.com/mtsac...d_Tutorial.pdf

    KZ750E Rebuild Thread...http://www.thegsresources.com/_forum...0-Resurrection

    Comment

    • stain

      #3
      Thanks. Wasn't using to time cams, I removed my gears and couldn't remember which way the marks went

      Comment

      Working...