Gs1100 still weeping oil

[m.qualls89]

I just did a top end rebuild not long ago. I'm weeping oil in the center of my head betwen the head and base where the small bolt that goes into the head is. I used copper gaskets for the head and base and yes I sprayed them. I have retourqued the head and replaced the orings on head nuts 1 & 3. Any ideas or am I stuck pulling it all off again?

[Guest]

My copper gaskets weep a little oil.
Unless you had everything machined perfect they may weep a little.
Is it wrappping around the engine and getting on you?

[m.qualls89]

Not getting on my but if I'm in traffic to long it starts burning off.