When reinstalling the cam shaft do i put oil in there....
-
-
Not oil, but i'm sure i wont be alone in suggesting a good moly based assembly lube. You have to pre lube it all. -
Personally, I use oil.
Not too sure about adding anything with moly in an engine with a wet clutch.
.sigpic
mine: 2000 Honda GoldWing GL1500SE and 1980 GS850G'K' "Junior"
hers: 1982 GS850GL - "Angel" and 1969 Suzuki T250 Scrambler
#1 son: 1986 Yamaha Venture Royale 1300 and 1982 GS650GL "Rat Bagger"
#2 son: 1980 GS1000G
Family Portrait
Siblings and Spouses
Mom's first ride
Want a copy of my valve adjust spreadsheet for your 2-valve per cylinder engine? Send me an e-mail request (not a PM)
(Click on my username in the upper-left corner for e-mail info.)Comment
-
I lightly coat my cam lobes and cam cap bearings with assembly lube.
Do not use a lot since it is bad for your clutch as Steve stated.Comment
-
With the shim and bucket engines there is a pocket which holds oil. A little oil on the bearing saddles and cam caps, then fill up the pocket all the way before installing the valve cover.Ed
To measure is to know.
Mikuni O-ring Kits For Sale...https://www.thegsresources.com/_foru...ts#post1703182
Top Newbie Mistakes thread...http://www.thegsresources.com/_forum...d.php?t=171846
Carb rebuild tutorial...https://gsarchive.bwringer.com/mtsac...d_Tutorial.pdf
KZ750E Rebuild Thread...http://www.thegsresources.com/_forum...0-ResurrectionComment
-
Here what it says in the manual:
"Just before placing the camshaft on the cylinder head apply high quality molybdenum disulfide lubricant to its journals fully coating each journal with the paste taking care not to leave any dry spot. Apply engine oil to the journal bearings."Comment
-
thanks guysComment
Comment