Accidentally broke the bracket switching out the old bent clutch shift rod. Anyone have an idea on how to fix it? Should i just hire a welder or (gasp) rig something up?
The bracket is meant to hold a bearing that supports a spring (see diagram http://imgur.com/PA4Vny4 #25/#26)
I suppose using JB weld and a small piece of aluminum with a hole in it aligned with the hole on the opposite side of the case would not be the best idea?
Anyone ideas?
See images of unfortunate destruction below.
The bracket is meant to hold a bearing that supports a spring (see diagram http://imgur.com/PA4Vny4 #25/#26)
I suppose using JB weld and a small piece of aluminum with a hole in it aligned with the hole on the opposite side of the case would not be the best idea?
Anyone ideas?
See images of unfortunate destruction below.
Comment