Head gaskets

[dennis]

Does anyone have an easier way to remove old head gaskets ? I have been using gasket remover and a razor blade ( very carefully i might add ), taking a very long time. Ive read about so many different methods,some are pretty hair brained.If anyone would know about the delicacies of a GS motorcycles it would be you guys.

Thanks

[blowerbike]

one sided razor in a scraping motion(straight up and down) and then some scotch brite.
you don't have to be so gentle.

[dennis]

Thanks works much better

[Gregory]

Not trying to hijack, but since I am doing the same thing right now and I have a very stubborn head gasket I figure it is ok to ask here.

You mentioned gasket remover....did it soften it up?

I have been using a single edge razor blade but can only get a little off at a time. I am worried about the debris getting in the engine and am having trouble keeping it out. Any suggestions?

[blowerbike]

put something in the holes and then blow the debris out/off with air when finished...wipe with thinner or carb cleaner...assemble.
i have never used gasket remover...i am the gasket remover and i always hated clean up...worse part of any job...

[dennis]

It softened it a little at a time,ive been using utility knife blades they are working better then the single edge blades.As far as keeping debris out of the engine im just using rags.When im done im going to flush out the engine with the oil pan removed.I just came to the conclusion that its going to be a slow and tedious process.

[wymple]

I use a putty knife sharpened down on one side. Nice and wide to avoid gouging, works great.

[jeff.saunders]

The best tool I've found is the Super Scraper from Goodson. Safe and very good...
Super-Scraper - 1 1/4" wide/