Honing

Collapse
X
 
  • Time
  • Show
Clear All
new posts
  • EliteInc
    • Feb 2026

    #1

    Honing

    I honed my cylinders yesterday. Everything looks pretty good but I did find a bad vertical gash in one of the cylinder walls. I'm not going to worry to much with it for now. When the time comes I'll have it bored. Tell me if the crosshatch looks fairly good.

    Not sure if these will turn out






    Last edited by Guest; 08-26-2015, 03:27 AM.
  • posplayr
    Forum LongTimer
    GSResource Superstar
    Past Site Supporter
    • Dec 2007
    • 23673
    • Tucson Az

    #2
    It is hard to see; if you can't catch it with your fingernail it might be OK. I had a similar issue from a folded oil ring; I have a 1166 kit now

    Comment

    • EliteInc

      #3
      I can barely catch it on the finger nail. The rings on all the pistions are in good shape so it's a little odd. Seems like I'd find a bad ring to cause a gash.

      Comment

      Working...