Is my motor number GS1000-127390 a 1979?
Will the GS850 or 750 clutch assembly fit my GS1000? As in the entire show... It's all gone inside there...
The entire ignition, flywheel, starter clutch, and chain cover. As above I can find them for the smaller bikes and newer ones cheaper.
Also, Back in the day guys used to throw away the carbs and run a set of side drafts on their CB750's. Had one back in the day like that. I'm probably going to attempt this and will build my own manifold. Other than hardcore fans of factory stuff is there a reason to avoid this? I do realize that this is not the most practical and the cost will be about the same as will the labor. I assume that dejetting is needed since the carbs would be for basically twice the CC's.
My attempts to find parts have been poor. I know that I want to put new bearings and gaskets with rings in this at a minimum but haven't found any real kits on the web yet. I admit to not looking very hard because I don't know if I got my year right or close enough and it appears to be a changing point for the parts.
Dennis
Comment