And before I go

[Bopi]

Have any of you seen this method of dent removal

http://www.metacafe.com/watch/501379/remove_car_dent_with_airduster/

[j.w.napier]

???????????

if that don't beat all.:shock: never seen it done like that.8-[ when your as broke as i am little bits of info like this help thanks bo\\/pi

J.W.Napier

[ron bayless]

That is really neat.where would buy the co2 stuff?

[Fare]

That is really neat.where would buy the co2 stuff?

It looks like the "air dusters" you can get for computer keyboards...

As I watched that, I thought about the dent in my gas tank from why my cat knocked it over. then I thought, oh wait, gasoline+heat != fun...on a bike at least.

[Nessism]

I tried this technique and it didn't work on my tank. I thought it might help since one of the dents was fairly shallow and had no creases.

I did have some success with one of those glue-on dent pullers - $25 from Harbor Freight. http://www.harborfreight.com/cpi/cta...emnumber=94925

Gets out shallow dents but also pulled off pieces of clear coat over the pin stripes.

[the_journeyman]

Somtimes you can use a toilet plunger on shallow & creasless dents. Use something gooey to make a better seal on between the plunger & metal. On a bike, I might be tricky ~

JM