79 gs 850bobber

[dhayward312]

At the shaft I decided to cut the coilover bosses off and weld them on. Figured it would give it a little cushion.

[dhayward312]

I'll leave you guys with some more teaser shots!!

[dhayward312]

1 more

[dhayward312]

Added some gussets and made seat mount. The fender is just sitting there....any suggestions on how to mount it???

[Hammered]

Added some gussets and made seat mount. The fender is just sitting there....any suggestions on how to mount it???

Come off youre hardtail upper tubes. Do fender struts. just remember to give no less than an inch to allow for tire swell and such. I like to use a section of large dia. garden hose for the offset. And if you run a strond enough set of struts on it, you can allow for a P-Pad too. Looking good.

[dhayward312]

Should i make a front mount too?? I was kinda thinking of getting some 1/2 square and twisting it for the strut and ending in a sissy bar....

[Hammered]

Should i make a front mount too?? I was kinda thinking of getting some 1/2 square and twisting it for the strut and ending in a sissy bar....

I would. Something simple and small to hold it in place. Would hate to see it break free and get slapped around by the chain there. Id just run a piece of 1/4" by 1" flat stock between the 2 down tubes there and bolt it to it with a rubber washer for shock and vibration. Its kinda the way Im remounting mine on the swingarm chop Im building. But my fender is a bit more expose so I can use my stock modifies tail/brake light. Ill pop a shot or 2 of my setup so you can see what it looks like.

[elevatorman71]

Here is a picture of the frame hacked off!! My tube should be in tomorrow so hopefully i'll have more updates...

whats the possibility of a side picture to see just whats going on there

[Henryinva]

Put a couple of spacers off the crossbar under the seat and a set of fender struts at the rear. That'll do it, thats how I did mine. Used a front fender just like you too!

[Henryinva]

Heres a pic for ya

[silverkrown]

There was a lot of good tips already but this is what I did on my shaft drive chop. I usually use some hose taped to the tire and maybe a rag on top. Leave a little extra room for swelling. I mounted mine in the winter and it was fine but in the summer it rubbed and I had to remove it and fix it. I bolted fender struts to the frame and fender. I also welded a tab to the seat cross bar and ran a bolt through that and the fender. Sorry I don't have a close up pic of it.

[dhayward312]

So i scrapped the stock tank idea and have decided to go with the sportster tank. Also got the fender halfway mounted..I'm going to make the struts at work tomorrow. Also scrapped the seat i was going to use, and made a bigger one. I'm having a local amish guy skin it...

[dhayward312]

Seat, fender, and spring mounts. Thanks for the ideas on this guys..

[dhayward312]

Last one for the night.. The new seat. I kno i kno...its HUGE, but i have a big behind.

[dhayward312]

Also, any suggestions on how to arrange the electrical?? I found a simplified wire schematic for a 1000 in jmcolorado's bobber build, but i dont know if they are the same??