:twisted: I was wondering if anewone could tell me how to remove the rear fender he one the lisince plate is atached to like in the galories to get a more agresive look
-
-
What bike do you have? -
:twisted: 1981 GS650EComment
-
A dremel, a fiberglass cutting wheel, about 15 min.Comment
-
:twisted: speeeeeeeeeeeeeeeed is awesomeComment
-
no one said speed was bad :twisted: . but it does kill
Comment
-
I just used a hacksaw to cut the whole thing off, and some sandpaper to tidy up the job. then had a bracket made to fit the plate just under the stop light. Rather than fitting extra license plate lights I chopped out a section on the bottom of the stoplight and replaced it with clear plastic, works fine.Comment
-
jd you got a photo?78 GS1000 Yosh replica racer project, 82 Kat 1000, 10 990 ADV-R, Some dirt bikesComment
-
I used a air tool and a 3 inch cutting disc.....
buzzz...zzz......zzzz whiszzz
it sounds like a bad day at the dentistComment
-
It's a blatent, simplistic lie - don't fall for it.no one said speed was bad . but it does killComment
Comment