Can the badge screw plates on the sides of a gas tank be removed? I bought a 1000E tank for use on my 1000S and the S had decals on the tank, not badges.
-
Ed
To measure is to know.
Mikuni O-ring Kits For Sale...https://www.thegsresources.com/_foru...ts#post1703182
Top Newbie Mistakes thread...http://www.thegsresources.com/_forum...d.php?t=171846
Carb rebuild tutorial...https://gsarchive.bwringer.com/mtsac...d_Tutorial.pdf
KZ750E Rebuild Thread...http://www.thegsresources.com/_forum...0-Resurrection -
Not quite sure, but as I remember the badge plates look like they're spot welded into some depressions on the side of the tank... I would think you could remove them, but then you'd have to fill in the depressions... -
Ed
To measure is to know.
Mikuni O-ring Kits For Sale...https://www.thegsresources.com/_foru...ts#post1703182
Top Newbie Mistakes thread...http://www.thegsresources.com/_forum...d.php?t=171846
Carb rebuild tutorial...https://gsarchive.bwringer.com/mtsac...d_Tutorial.pdf
KZ750E Rebuild Thread...http://www.thegsresources.com/_forum...0-ResurrectionComment
-
I just did this on my 750. I used a dremel to slowly cut away where the spot welds are. On mine there were 3 spot welds. One on each end and one in the middle. It was a lot easier than I thought it would be.Comment
Comment