looking for the measurements for the screws that hold the emblem on i did a search on here and seen 2 different answers 3mm x 6mm and 3mm x 5mm would either work i have a 78 gs1000 i found the part to order online but it didn't have the measurements listed and id rather just go to lowes or home depot
-
-
Buy both and then report back on which is best. They are just screws.Ed
To measure is to know.
Mikuni O-ring Kits For Sale...https://www.thegsresources.com/_foru...ts#post1703182
Top Newbie Mistakes thread...http://www.thegsresources.com/_forum...d.php?t=171846
Carb rebuild tutorial...https://gsarchive.bwringer.com/mtsac...d_Tutorial.pdf
KZ750E Rebuild Thread...http://www.thegsresources.com/_forum...0-Resurrection -
The part number is 02132-03065. Look right after the dash, you will see that it is 03mm diameter, 06mm long. Never have figured out the 5, not sure if it is head type, color, supplier or what.Comment
-
yea i will probably do that since they don't cost muchComment
-
ok thanks maybe it means or 5mm lolComment
-
If you go even a tiny bit too long the screw will puncture your tank, and it's hard to fix it there!Comment
-
yea thats what i was trying to avoidComment
-
it is the 3mm x 6mm lowes and home depot didnt carry anthing smaller than a 4mm but i found some for 19 cents at a hardware store called phelps do it best they are even blackComment
Comment