Weak idle until hot

[DimitriT]

Hi folks, got a 82 GS550L with 60k on her. Daily ride. This season seems to have developed a problem where the idle gets weak when the bike is partially warmed up. Bike starts great when cold and idles on choke and off choke (after about a mile on a mild temp day). It also idles strong when fully warmed up (by that I mean a 20 min ride on the highway or something like that). But when the bike is half warmed up (like a slow 2 or 3 mile ride) the idle is really weak and needs a blip of throttle to keep running. I noticed this more after an oil change (Pennzoil 10w40). Also when the bike idles weak it will do a little better in neutral as opposed to being in gear with the clutch pulled in. Could the clutch be dragging? The oil change also seemed to bring on some gear change roughness but that cleared up after a couple of hundred miles. I posted this in carb section but this could go in the engine section.

Do folks run 5w40 oil?

Carbs feel well balanced and clean (rides smooth and strong off throttle). Ignition system looks fine. Yanking the ignition wires indicates that all cylinders are contributing but #3 seems a little weaker but not bad. I've had this bike for 20+ years and this is literally the only problem I have with it.

[Rob S.]

Could the clutch be dragging?

That seems obvious to me. Am I wrong?

[DimitriT]

What can I do about it? Only thing I know about clutch is the little adjustment wheel on the clutch lever. Also why would it idle ok in gear when cold but not when partially warmed up? Does the clutch tolerance change as it heats up?

[Buffalo Bill]

This seems normal to me, old air cooled bikes need to be fully warmed up before idling well, they're analog. It takes progressively longer as the weather gets colder.
PS: In the manual for the same vintage Honda CB750F the use of a thinner oil in winter is recommended.

PPS: As for clutch drag, test that by pulling the bike up on it's center stand and see if the wheel spins while idling in neutral.

[Cipher]

Hi folks, got a 82 GS550L with 60k on her. Daily ride. This season seems to have developed a problem where the idle gets weak when the bike is partially warmed up. Bike starts great when cold and idles on choke and off choke (after about a mile on a mild temp day). It also idles strong when fully warmed up (by that I mean a 20 min ride on the highway or something like that). But when the bike is half warmed up (like a slow 2 or 3 mile ride) the idle is really weak and needs a blip of throttle to keep running. I noticed this more after an oil change (Pennzoil 10w40). Also when the bike idles weak it will do a little better in neutral as opposed to being in gear with the clutch pulled in. Could the clutch be dragging? The oil change also seemed to bring on some gear change roughness but that cleared up after a couple of hundred miles. I posted this in carb section but this could go in the engine section.

Do folks run 5w40 oil?

Carbs feel well balanced and clean (rides smooth and strong off throttle). Ignition system looks fine. Yanking the ignition wires indicates that all cylinders are contributing but #3 seems a little weaker but not bad. I've had this bike for 20+ years and this is literally the only problem I have with it.

Sucking air till heat expands parts and seals.
unless your clutch has adjusted itself by means of cable stretch.
or the oils viscosity rating across Temps is some odd variable. Check Pennzoil site for specs. Iirc only two Temps are test points so........

clutch us easy to check use the fine manual if adjustment needed..

[DimitriT]

Today I followed the same route as usual and got a steady idle at the stops where it would stall before. Air temps were about the same but the bike just ran better. Now I'm thinking maybe its an intermittent ignition thing.

[lizzywhite45]

This is pretty common with older air-cooled bikes. They need to be fully warmed up for a smooth idle. Weak idle when partly warm could be oil viscosity or a dragging clutch.

Try 5w40 oil for smoother shifts and less drag. Check carb sync and fuel screws too,small tweaks can help. If #3 cylinder feels weak, swap plugs or wires. Also, check clutch free play at lever and case.

Old bikes can be tricky but with patience you’ll fix it.

[Griffin]

Use Shell Rotella T4 or T6 15W-40. Your clutch and valve train will thank you.

As for the idle, it's an odd pattern if it idles ok when cold, then goes through a temp range where it idles poorly, then gets hotter and idles better. With the clutch pulled in agrravating the issue, it points more to a dragging clutch.

As was mentioned, put the bike on the centerstand, put it in frist gear, and see if the rear wheel turns. If it does and your cable is out of adjustment range, get a new cable, OEM if you can find one.

[Rob S.]

As was mentioned, put the bike on the centerstand, put it in frist gear, and see if the rear wheel turns. If it does and your cable is out of adjustment range, get a new cable, OEM if you can find one.

Isn't it supposed to do that?

[Griffin]

You're right Rob. I meant "put the bike in neutral", not first gear.

[DimitriT]

Use Shell Rotella T4 or T6 15W-40. Your clutch and valve train will thank you.

As for the idle, it's an odd pattern if it idles ok when cold, then goes through a temp range where it idles poorly, then gets hotter and idles better. With the clutch pulled in agrravating the issue, it points more to a dragging clutch.

As was mentioned, put the bike on the centerstand, put it in frist gear, and see if the rear wheel turns. If it does and your cable is out of adjustment range, get a new cable, OEM if you can find one.

Is there some adjustment I can make either at the clutch lever or at the left engine cover which will have the clutch pull a little further to account for a stretched cable?

[oldGSfan]

Use Shell Rotella T4 or T6 15W-40. Your clutch and valve train will thank you.

As for the idle, it's an odd pattern if it idles ok when cold, then goes through a temp range where it idles poorly, then gets hotter and idles better. With the clutch pulled in agrravating the issue, it points more to a dragging clutch.

As was mentioned, put the bike on the centerstand, put it in frist gear, and see if the rear wheel turns. If it does and your cable is out of adjustment range, get a new cable, OEM if you can find one.

T6 is $30 OTD at the major stores and there's a $15 rebate right now on a gallon. Just picked up some. Their website says which stores are valid for the rebate.

[Rob S.]

Is there some adjustment I can make either at the clutch lever or at the left engine cover which will have the clutch pull a little further to account for a stretched cable?

There is adjustment at both those places. On mine ('82 11E) it's on the right side of the engine, right on top of...wait for it...the clutch.