It runs a few days ago both pre fire and post fire.
- Carbs have been completely cleaned, new o rings etc etc dip yeah.
- New pilot air screws 3 turns out, even 2 turns nothing (havent had a chance to adjust them yet)
- Pods... still started fine before with them but I have new mains on the way and will raise the needles.
- Have spark and compression all 4 cyl/ plugs
- Fresh fuel being put in via gravity fed funnel off handle bars protected by an inline valve for my safety and no where near the battery (Never again!)
- Floats are stopping fuel flow when bowls are full.
- No loss of power to the coils
- No airleaks and vacuum port is capped.
- Choke works properly.
- Valves are all adjusted
What am I doing wrong/ missing.
Seriously I cant afford to take it to a shop and I'm running out of time and patience.

Comment