Carb Questioning

[Diablo1982]

I recently picked up a set of 81 gs1100 carbs. I was told by the gentleman that they were jetted to where if u use a 4into1 pipe and stock airbox they will be fine.

My question is that will the 1100 carbs compat to the 81 1000 i have and????????????????????????????????

[Steve]

Only plug chops will tell you for sure.

.

[tkent02]

So I guess you no longer want the ones I have been saving for you for six months?

[Big T]

I'd be opening them up and seeing what jets are in there before I installed them

[Katarat]

I doubt theres any benefit from one set over the other jetted the same, they are both 34mm Cvs

[Diablo1982]

Starters Tkent, they were a gift and ur hard as **** to get ahold of. lol. I really never sat and compared the jets so i dont know what ot look for in differences.

[tkent02]

Starters Tkent, they were a gift and ur hard as **** to get ahold of.

Tried Email or a PM? Maybe another text message? How about an old fashioned phone call?

[Diablo1982]

Anywho, the gentleman these carbs came from owns a bike place here in Kansas, He told me that the carbs are jetted great as long as you use a 4 into 1 pipe, I took bowls off and tops off and everything is checking out ot look hella clean, everythings free and moves well.

I have never installed carbs from 1 model to another and i am wandering if all the cables and such will work, will they run well on the engine and etc..............

[Detroit Diesel Man]

I believe basscliffs site has a chart that shows stock jetting on each model...that should get you a baseline for what they should be and how they compare then you can go from their as far as if they would work.


DDM

[Diablo1982]

thanks detroit

[StaticEccho]

i rebuild carbs mostly with gs bikes on ebay, i would say no they wont fit they will most likly be to small by 1 or 2mm from left to right. i dont have a set infront of me to tell but that is
staticecco
gs1100 carb clean rebuild service on ebay

[Rudeman]

i rebuild carbs mostly with gs bikes on ebay, i would say no they wont fit they will most likly be to small by 1 or 2mm from left to right. i dont have a set infront of me to tell but that is
staticecco
gs1100 carb clean rebuild service on ebay

I've taken VM33s off my GS1000 8V and installed them on a GS1100 16V and they bolted up perfectly; so spacing issues.

They should fit fine. Just need to make sure they are jetted corectly.