Also, I'm having idle issues. It likes to idle really high on full choke, like 4-5000 RPM. When I get it warmed up, the idle likes to slowly creep down when I set it around 1100 till it dies. I can turn up the idle screw to keep it idling, but then when I give it gas the idle sticks high and i have to turn it back down. Will going up a size in pilot jets fix this? If so, how much (40 stock)?
Im having issues with my bike holding high rpm's to. I can get it to rev up smoothly, but it won't hold higher rpm's, sounds like it runs out of gas. If I hold the throttle it bogs like it's out of gas, then revs back up and repeats the same process over. Petcock flows fine, but how would I go about checking how much vaccum the carbs are pulling on the vaccum line? Will jetting and proper carb settings fix this, or am I looking at clogged passages and carb float heights? I cleaned the carbs, but wouldn't hurt to check again.