Greetings. Are you aware of a previous post (image) that describes centering throttle linkage from the end of throttle bodies?. In this instance the the TB's are individual assemblies. Thank you in advance for your efforts.
-
-
A bit confused, by your question.
What are you trying to do? Are you putting things back together after a carb clean? If so, the throttle shaft has detents where the set screws rest, that aligns everything for you. If you are spacing a set of flat sides for a custom set up. you have a few options.
I've done both.
What bike are you working on?
Which carbs are you working with?
Comment