Hey guys, my 1000 is coming along, but still has a few issues. I have gotten a lot of good information from this site, that has really made a HUGE difference. Now granted, the stock airbox I found is not here yet, neither is my carbtune, so I haven't got everything squared away, however I do have a general question or two.
First, after bench syncing my carbs, setting the mix screws out 2.5 turns, and adding new intake boot o-ring, her idle is down to a normal level, what a relief. That being said, my problems right now are this. No fire on cyl 4, and one of the carbs is still backfiring alot, i am not sure, but Its either 3 or 4, leaning to four because of the no fire on that cylinder. What do you guys think this could be. It backfires a LOT when I try to rev it. I know its getting spark to the plug, because I could feel it in my hand when I pulled the wire off with no change
, haha.
On a side note, at low rpms (800-1200 or so) there is a nasty rattle coming from what sounds like the back of the motor, but it clears COMPLETELY after those low rpms, any takers?
First, after bench syncing my carbs, setting the mix screws out 2.5 turns, and adding new intake boot o-ring, her idle is down to a normal level, what a relief. That being said, my problems right now are this. No fire on cyl 4, and one of the carbs is still backfiring alot, i am not sure, but Its either 3 or 4, leaning to four because of the no fire on that cylinder. What do you guys think this could be. It backfires a LOT when I try to rev it. I know its getting spark to the plug, because I could feel it in my hand when I pulled the wire off with no change
, haha.On a side note, at low rpms (800-1200 or so) there is a nasty rattle coming from what sounds like the back of the motor, but it clears COMPLETELY after those low rpms, any takers?
Comment