Announcement
Collapse
No announcement yet.
Exhaust flange bolts
Collapse
X
-
JayWB
You install studs by putting 2 nuts on one end and tighten (jam) them together. You then install the stud as if it were a bolt, using a wrench on the outer nut. Once you get it installed you hold the inner nut with a wrench and loosen the outer nut. Once they're un-jammed you can remove both nuts with your fingers.
-
twodogs58
NAPA stud kit
they carry an exhaust stud kit that i believe is a usable size m8x1.0x55? that has 10 stud/nuts for about 13.00. picked one up the other day will dig out the part number and post. got the part# from another post on this site.
Comment
-
7981GS
Tap the blind holes all the way to the bottom and you still may have to shorten the studs to gain enough clearance for the flanges to clear the frame tubes.Originally posted by twodogs58 View Postthey carry an exhaust stud kit that i believe is a usable size m8x1.0x55? that has 10 stud/nuts for about 13.00. picked one up the other day will dig out the part number and post. got the part# from another post on this site.
Eric
Comment
.png)
Comment