fuel leaking out exhaust

Collapse
X
 
  • Time
  • Show
Clear All
new posts
  • Qhergt

    #1

    fuel leaking out exhaust

    So I put my 82 GS400 on the center stand (slightly down hill)and after a few min noticed fuel leaking out the exhaust. This didn't happen when it was on the side stand.
  • Nessism
    Forum LongTimer
    GSResource Superstar
    Past Site Supporter
    Super Site Supporter
    • Mar 2006
    • 35787
    • Torrance, CA

    #2
    Sure it's fuel instead of condensation?

    If it's fuel, then you also have fuel in the crankcase as well. NOT good. Either a float is stuck and/or your petcock is dumping fuel down the vacuum line.
    Ed

    To measure is to know.

    Mikuni O-ring Kits For Sale...https://www.thegsresources.com/_foru...ts#post1703182

    Top Newbie Mistakes thread...http://www.thegsresources.com/_forum...d.php?t=171846

    Carb rebuild tutorial...https://gsarchive.bwringer.com/mtsac...d_Tutorial.pdf

    KZ750E Rebuild Thread...http://www.thegsresources.com/_forum...0-Resurrection

    Comment

    • Qhergt

      #3
      Originally posted by Nessism
      Sure it's fuel instead of condensation?

      If it's fuel, then you also have fuel in the crankcase as well. NOT good. Either a float is stuck and/or your petcock is dumping fuel down the vacuum line.
      How would I test to see which it is?

      Comment

      • Qhergt

        #4
        No fuel in the vacume line.. So I'm guessing stuck float... Which makes sence now that I think about it as I bought the bike recently and it had been sitting for a while and had bad gas and rust in the tank. Bike stalled out on me and so I pulled the tank, cleaned and relined it. Cleaned out the pet and found crap in it that got though the broken strainer.. Replaced the strainer as well. So some stuff prob did get into the carb.

        So, I guess ill have to pull the float chambers out, remove and clean the floats, squirt carb cleaner into it and dump some sea foam or other intank carb cleaner into the tank. And do an oil change??

        Comment

        • Nessism
          Forum LongTimer
          GSResource Superstar
          Past Site Supporter
          Super Site Supporter
          • Mar 2006
          • 35787
          • Torrance, CA

          #5
          Originally posted by Qhergt

          So, I guess ill have to pull the float chambers out, remove and clean the floats, squirt carb cleaner into it and dump some sea foam or other intank carb cleaner into the tank. And do an oil change??
          At minimum. I recommend a full carb rebuild with fresh O-rings. Check Basscliff's site for info.
          Ed

          To measure is to know.

          Mikuni O-ring Kits For Sale...https://www.thegsresources.com/_foru...ts#post1703182

          Top Newbie Mistakes thread...http://www.thegsresources.com/_forum...d.php?t=171846

          Carb rebuild tutorial...https://gsarchive.bwringer.com/mtsac...d_Tutorial.pdf

          KZ750E Rebuild Thread...http://www.thegsresources.com/_forum...0-Resurrection

          Comment

          • Qhergt

            #6
            Originally posted by Nessism
            At minimum. I recommend a full carb rebuild with fresh O-rings. Check Basscliff's site for info.
            Previous owner had the carbs rebuilt and cleaned few months ago. Ill try just cleaning the floats out carb cleaner in the tank and spray. If that doesn't do it ill do a rebuild.

            Comment

            • tkent02
              Forum LongTimer
              Past Site Supporter
              • Jan 2006
              • 35571
              • Near South Park

              #7
              Where have I heard this before?
              http://img.photobucket.com/albums/v5...tatesMap-1.jpg

              Life is too short to ride an L.

              Comment

              • Nessism
                Forum LongTimer
                GSResource Superstar
                Past Site Supporter
                Super Site Supporter
                • Mar 2006
                • 35787
                • Torrance, CA

                #8
                No $hit. Wish I had a nickel for every person that short cutted the carb rebuild and wound up having to do it twice...or three times.
                Ed

                To measure is to know.

                Mikuni O-ring Kits For Sale...https://www.thegsresources.com/_foru...ts#post1703182

                Top Newbie Mistakes thread...http://www.thegsresources.com/_forum...d.php?t=171846

                Carb rebuild tutorial...https://gsarchive.bwringer.com/mtsac...d_Tutorial.pdf

                KZ750E Rebuild Thread...http://www.thegsresources.com/_forum...0-Resurrection

                Comment

                • tkent02
                  Forum LongTimer
                  Past Site Supporter
                  • Jan 2006
                  • 35571
                  • Near South Park

                  #9
                  Here we go again, a stuck float, or anything else in the carburetor, cannot possibly fill the crankcase with fuel if the petcock is working correctly, and is not left in the PRI position.

                  Did you even find out if the crankcase is full of fuel?
                  http://img.photobucket.com/albums/v5...tatesMap-1.jpg

                  Life is too short to ride an L.

                  Comment

                  • tom203
                    Forum Guru
                    Past Site Supporter
                    • Aug 2010
                    • 8925
                    • Norway,Maine

                    #10
                    Originally posted by tkent02
                    Here we go again, a stuck float, or anything else in the carburetor, cannot possibly fill the crankcase with fuel if the petcock is working correctly, and is not left in the PRI position.

                    Did you even find out if the crankcase is full of fuel?
                    Maybe you should check petcock for correct operation while seafoam attempts a cure. Most likely,the crap that was in your tank has found a new home and will be difficult to dislodge.
                    1981 gs650L

                    "We are all born ignorant, but you have to work hard to stay stupid" Ben Franklin

                    Comment

                    • Qhergt

                      #11
                      I had cleaned out the petcock the other day. Realiized as I was putting the carb bowls back on after cleaning them and the floats out with carb cleaner that I had left it on prime... Opps. Needed an oil change anyway. All is well now, just letting the bike run a bit to clear that carb cleaner out as its running at a very low idle now.

                      Comment

                      • tkent02
                        Forum LongTimer
                        Past Site Supporter
                        • Jan 2006
                        • 35571
                        • Near South Park

                        #12
                        Originally posted by Qhergt
                        All is well now, just letting the bike run a bit to clear that carb cleaner out as its running at a very low idle now.
                        Dude, it's air cooled. Ride it.
                        http://img.photobucket.com/albums/v5...tatesMap-1.jpg

                        Life is too short to ride an L.

                        Comment

                        Working...