Carburetor lesson.
Just courious, on CV carbs when you twist thethrottle the butterfly's open. What causes the slides to raise up? Ya, I know I should have know this, but I don't!!
-
-
Air rushing under the slides will have a slightly lower pressure as it passes through the venturi.
There is a hole on the bottom of the slide that lets that vacuum get through the slide and get above the diaphragm, where it will lift the slide.
It has nothing to do with the engine vacuum, which is what you will see between the butterflies and the intake valve, it is entirely dependent on the velocity of the air under the slide.
Because the slides only open in response to greater volumes of air, it is almost impossible to bog them down by suddenly whacking them open at low speed.
While this feature makes them very friendly for everyday street use, it makes these carbs rather undesirable for track use.
.sigpic
mine: 2000 Honda GoldWing GL1500SE and 1980 GS850G'K' "Junior"
hers: 1982 GS850GL - "Angel" and 1969 Suzuki T250 Scrambler
#1 son: 1986 Yamaha Venture Royale 1300 and 1982 GS650GL "Rat Bagger"
#2 son: 1980 GS1000G
Family Portrait
Siblings and Spouses
Mom's first ride
Want a copy of my valve adjust spreadsheet for your 2-valve per cylinder engine? Send me an e-mail request (not a PM)
(Click on my username in the upper-left corner for e-mail info.) -
Vacuum
(The message you have entered is too short. Please lengthen your message to at least 10 characters)Ed
To measure is to know.
Mikuni O-ring Kits For Sale...https://www.thegsresources.com/_foru...ts#post1703182
Top Newbie Mistakes thread...http://www.thegsresources.com/_forum...d.php?t=171846
Carb rebuild tutorial...https://gsarchive.bwringer.com/mtsac...d_Tutorial.pdf
KZ750E Rebuild Thread...http://www.thegsresources.com/_forum...0-ResurrectionComment
-
Thank You! That's almost to simple! I am guessing if you had a leaking diapgram that would cause problems!! Well, mystery over. I thought there would be a more complicated way of making them open. What'ya know!!Comment
-
Comment