Fuel mixture screw

[rlg5]

HI does annyone know to reinstall the air fuel mixture screw after rebuilding the carbs i mean how the little spring little washer and o ring go back in , i dont remember what order they came out ,carbs are off a 86 gs 550esg.I cant seem to find any pictures
THANKS !!!!

[Ton1959]

You don't mean spring, washer, o ring?

[ART]

In order they go on: Spring, washer, o-ring.

[Thumper88]

[Agemax]

spring,washer,o ring. that way o ring seals up against the seat and the washer stops the spring from chewing up the o ring as you turn the screw.

[OLDENUFF]

I agree with agemax. Spring, washer,oring.

[trippivot]

picture is WRONG!

you want the Oring to seal against the carb body and the washer to protect the o ring from the spring and the spring prevents the screw from dropping out. .

spring onto mixture screw first
washer onto mixture screw next to the spring -
O-ring goes on last last. and it holds them on the mixture screw while you install the assy into carb body.

install until lightly fully seated. then come out 2 full turns and begin carb idle drop tuning from there. (bike will start easier if you do it that way. )

[rlg5]

fuel mixture screw

Thanks a bunch guys!!

[gbeckhart]

Hey Guys, need some help here. I have an 82 GS650 which according to manual uses Mikuni BS32 ss carburetors. I am looking for the air/fuel mixture screws that go on top front of each carburetor. I cannot seem to find the correct part number. I do see these screws for GS750 and GS1100 but nothing for the 650. Any of you would happen to know what would be the part number or where I can purchase these screws?

Thanks All, good and safe riding!

[P09luis]

Did you ever find the part number for that air fuel mixture screw? I need one or a set for my GS1100 and can't find the part number anywhere