Help please
Collapse
X
-
Help please
1982 gs750t. I just cleaned my carbs. I dipped them for 8 hours each, i cleaned every hole with a wire. I set the air screws to 2.5 each. The bike doesn't want to start. I finally got the bike started and it wants to ideal at 4k. When I add throttle in short burst it will rev up. If I keep the throttle on it will die. I got the battery tested and it's good. What should I do? -
Did it start, run and idle normally before you cleaned the carbs? Did you disassemble the carbs COMPLETELY? Did you replace all the rubber "O" rings in the carbs?Komorebi-The light filtering through the trees.
I would rather sit on a pumpkin and have it all to myself than be crowded on a velvet cushion. H.D.T. -
Guest -
Master077
I took the carbs off because the bike would not start. Before this problem the bike would idle perfect. I replaced all off the orings.Comment
-
Master077
I did a coil relay mod and now I am getting 11 volts at coils when starting bike. I also installed new spark plugsComment
-
Guest
Did you do a near perfect bench synch on the carbs? or better yet have you had them vacuumed synched?Comment
-
Doesn't want to start??? when you cleaned the carbs did you pay attention to "choke" circuit passages ? if it takes off to 4k, maybe the "choke" is sticking open -check cable for proper adjustment1981 gs650L
"We are all born ignorant, but you have to work hard to stay stupid" Ben FranklinComment
-
Master077
I did a bench sync. I used a safety pin to make sure they were all the same. Could I of sync the carbs to open? I got the orings from cycle orings .comComment
-
Master077 -
Master077
I just checked the idle screw. I unscrewed the idle screw and nothing changed. If I apply choke it idles at 6kComment
-
Master077 -
Master077
Comment
Comment