Close-up picture of Vance & Hines 4-1 street system on a GS1000E

[philosopheriam]

Folks,

I'm thinking about ditching my center stand and modifying my swingarm to accept spools on my 1978 GS1000E. However, I am concerned about possible interference between the spools and the inside of the exhaust near the swingarm - the plan is to install a Vance & Hines 4-1 street system (part 12005)

Can anyone take a closeup photo of the space between the exhaust and the swingarm? Your help is greatly appreciated.

[gordinho80]

Not sure if this helps... but my 83 GS1100G has a 4-1 V&H.

[philosopheriam]

Would you mind taking one closer up, from the top down so I can see how close the swingarm gets to the exhaust?

Greatly appreciated, sir!

[gordinho80]

Hope these help...

[Guest]

Hope these help...

OP is looking for some shots back by the axle, preferably looking down from above to see if there is room to have a race stand spool sticking out from the swingarm without it fouling the side the of the muffler. OP, I can't tell you if there is room on your 1000E, but I can say that there is room on my 82 1100E with a Kerker canister system.


Mark

[gordinho80]

[Rob S.]

My "Trackside" rear paddock stand came un assembled with parts for spindles or without. I have no centerstand, no spindles, and stand works just fine, lifts under the rear part of the swing arm.

[philosopheriam]

THANK YOU!!!!!

Everyone has been a big help - the pic by gordinho80 was EXACTLY what I was looking for. It looks like the exhaust is relatively close to the swingarm except for the last 4 to 6 inches where the chain adjuster and lower shock mount is located.