Reading the forum, I figured petcock, which was new btw, but not OEM. Pulled the tank, put a hose on the petcock air line. On "ON" and "RES", no fuel comes out unless I apply slight vacuum to air inlet (with a hose I sucked on. Admit it. You've done it.) On "Pri" fuel flows. I never use Pri and am careful to not put park it with PRI on. This seems to be, I think(?) indicative that the petcock is working as it should.
Just to be sure I've put it on the workbench with a paper towel under it to watch overnight for any drips.
Question one: Could it be the case that the vacuum line is leaving some vacuum on there even though the engine is not running, thus releasing fuel?
Question two: What else would explain this behavior?
Thanks as always.
Dan

Comment