VM Carb question.

[johnod]

79 GS1000S

VM Carbs, Synched with mercury gauges.

I'm not much on carbs, so could use some help. Bike starts fine idles pretty good( hunts a bit) runs fine at most any throttle position. The problem is sitting at idle, if i give it the slightest , and I do mean slightest, throttle it just dies, no sputter/cough, just stops.I'm talking about just basically resting your finger tips on the throttle grip, not grabbing a handful. I can get by that, and keep the revs above idle at stop lights so it doesn't stop, when I apply throttle from idle. Any ideas? Thanks.

[Steve]

Airbox installed?

.

[johnod]

Airbox installed?

.

Yes stock airbox, new boots as well, V&H 4 into 1 exhaust, dyna S ignition, almost completly stock bike

[Steve]

Larger jets installed for the pods and pipe?

What are the fuel screw (bottom of the carbs) and air screw (side of the carbs) settings?

.

[1948man]

You say idles good, is that at startup? After it is warm is it idling at a lower rpm. Idle should be set after bike as warm.

[johnod]

Larger jets installed for the pods and pipe?

What are the fuel screw (bottom of the carbs) and air screw (side of the carbs) settings?

.

I don't know.

[johnod]

You say idles good, is that at startup? After it is warm is it idling at a lower rpm. Idle should be set after bike as warm.

Idle is pretty good hot or cold.

[Big T]

What idle speed do you have it set at?
Should be 1100-1200