Will a GS1100e 16 valve 4 into 1 fit a 82 GS1100GK 8 Valve

[Guest]

Hello I have a naked 1982 GS1100GK that I'm looking to fit a 4 into 1 exhaust onto. Will an exhaust from a GS1100e 16 valve fit ?

This is the exhaust I'm looking at. Ty

https://www.ebay.ca/itm/265379351967?mkevt=1&mkpid=0&emsid=e11051.m43.l1123&mkcid=7&ch=osgood&euid=baac84c0ed72482ab9b543f780f7315e&bu=43755199041&osub=-1%7E1&crd=20211203130200&segname=11051&sojTags=ch%3Dch%2Cbu%3Dbu%2Cosub%3Dosub%2Ccrd%3Dcrd%2Csegname%3Dsegname%2Cchnl%3Dmkcid

[Guest]

Not sure if it will fit or not, but if you EVER hope to make a right-hand turn, you will have to slow down to just about a stop to do it. Those are the "sidewinder" pipes that are intended for drag bikes. "Drag" as in "dragstrip". If you use them on a 'normal' bike, the term "drag" takes on a whole new meaning.

[storm 64]

I'm not sure if it will fit your 8 valve head or not. But that is a nice old school drag pipe. I wish it was more local, I'd buy it!

[Rich82GS750TZ]

Not sure if it will fit or not, but if you EVER hope to make a right-hand turn, you will have to slow down to just about a stop to do it. Those are the "sidewinder" pipes that are intended for drag bikes. "Drag" as in "dragstrip". If you use them on a 'normal' bike, the term "drag" takes on a whole new meaning.

Yikes, you ain?t just whistlin? Dixie. Even with the bike leaning left on the side stand, the muffler tip looks to be about 2 inches off the pavement.

[Guest]

Thanks everyone. I've found a few videos that seem to confirm it fitting a 78-79 gs1000 a gs1100g and a 83 gs1100gk. The clearance looks to be fine as the bike in the pic I posted was lowered.

https://www.youtube.com/watch?v=3nbE5qywJ_s

https://www.youtube.com/watch?v=zB6eIJgIUgs

https://www.youtube.com/watch?v=MjTpyztuB7A