I want to make a coil-mod on my 1983 16-valve 750,I wonder how to connect to pig 86 on relay,Between kill switch and ingniter there is a O/W wire,and to this wire there are 2 more wires O/W going to coils,Am i suppose to get rid of the 2 O/W coil wires,and solder a new wire directly to the wire, between killswitch and igniter and then connect this to pig 86?And make a new wire from 87 to coils????
-
-
I used these instructions
To do my coil mods,
-
Actually just did this mod on my bike today, noticed earlier this week that it was only getting 9.5V at the coils, now getting full voltage. Made a significant difference across the rpm range.....anyway, I digress....
The directions I was following were:
Pin 30 goes to Battery 12V
85 goes to ground
Then you cut the O/W wire between the kill switch and igniter/coils.
pin 86 connects to the wire coming out of the kill switch
pin 87 connects to the coils/igniter
be sure to use a fuse on the line from the battery to pin 30!Comment
-
I would cut the O/W wire before the wire bundle where the kill switch meets the coils and igniter. Make this the trigger wire. I returned the switched wire back to the bundle and soldered it right in.Comment
Comment