FH001 r/r question

[kochic]

Hi, I bought off ebay a 2002 yamaha road star warrior R/R.
This is the same as a R1 R/R.
My question is every post i read about these r/r, they only state 5 wires.
My r/r has 2 plug, one grey and the other black, i know the grey is for the stator wire and the blacke the output.
But the black connector has 3 pin built in.
does it have a sense wire like a Honda?
Thank you,
Marc

[posplayr]

Hi, I bought off ebay a 2002 yamaha road star warrior R/R.
This is the same as a R1 R/R.
My question is every post i read about these r/r, they only state 5 wires.
My r/r has 2 plug, one grey and the other black, i know the grey is for the stator wire and the blacke the output.
But the black connector has 3 pin built in.
does it have a sense wire like a Honda?
Thank you,
Marc

Connections are shown in upper right, 3 for stator and 2 for (+)/(-)

http://www.shindengen.com/resources/Product/FH012AA.pdf

[kochic]

thank you Pos,
So, I just leave the middle pin free.
Marc

[posplayr]

thank you Pos,
So, I just leave the middle pin free.
Marc

There should be nothing to connect to, so yes leave it free

[salty_monk]

I installed one of those on a bike recently. Yes leave the middle one free, makes no difference to how it outputs to the battery at any RPM / load that I was able to test it at.

(I tested from idle to about 5k rpm with stock load & an extra 60w load applied).

Dan

[kochic]

Thanks,
This evening i rode the bike with the honda r/r , tomorrow i will install the fh001 and leave the pin free.
from what i read this is a better unit.
Marc

[Steve]

I have installed a couple FH008 regulators, they also have the third pin. Like salty_monk, I compared readings at different engine speeds, with different loads, with the third pin unconnected, connected to ground and connected to batt +. No difference in any of the readings.

.

[posplayr]

I have installed a couple FH008 regulators, they also have the third pin. Like salty_monk, I compared readings at different engine speeds, with different loads, with the third pin unconnected, connected to ground and connected to batt +. No difference in any of the readings.

.

Is there actually a spade coming out of the middle location?

[salty_monk]

Yes, on that RR there is a male spade in the middle of the +ve & the -ve.

Dan

[kochic]

My bike is now on the road
Thank you all, finally i mounted the yamaha r/r.This unit had give me better result.I will order connectors from eastern beaver next week.

Marc