Hi all, im in the middle of installing a trialtech unit on me GS1100E. it was going great untill started striping and splicing wires for the Nutral light, high beam, and turn signals. when i got it all hooked up i went to test it i had nothing! none of the lights worked it wouldn't turn over or anything. I gave it up for that night, and turned in. the next morning i put a meter on the batt and it was dead, i charged it and now its holding 12.96 volts. I left the key in the on position over night so that might have caused that even tho i dont know what was drawing current. I tried the bike again but still nada. I then checked the fuses, the head lamp and turn signal fuses were blown so i replaced thos, i figure just having all the wires exposed may have caused that could have shorted out. but still nothing. Does anyone have any ideas what this could be? im not very good with wiring any comments would be apreciated. at least i could check the suspected cause on the bike. thanks in advanced.sinceerly, mendomotox
or if someone could post a wiring diagram i might be able to figure it out. please
Comment