1985 GS700e key numbers
Collapse
X
-
rkj2002
1985 GS700e key numbers
Hi Guys, I'm trying to order a new key blank on ebay but I need the letters proceeding the numbers (sample- one letter followed by five numbers I think) on an original key. Can anyone give me these please. Thanks, RickTags: None -
rkj2002
Thanks sv, I don't think I have a set of numbered keys. I wonder if the USA bikes have the same key number configuration as yours.
Anybody in the states?
Regards, RickComment
-
Billy Ricks
If you have keys already just buy the blanks then take them to a locksmith or any place that cuts keys and have them cut them for you. My keys have TR and the 3 digit code.Comment
-
SVSooke -
Billy Ricks
This is where I got my blanks from.
And the Suzuki page.
You need the 4P blank, $7.00.Last edited by Guest; 01-26-2011, 08:13 PM.Comment
-
rkj2002
Thank you, thank you bothThis is where I got my blanks from.
And the Suzuki page.
You need the 4P blank, $7.00.
Comment
-
rkj2002
I just noticed on my ignition switch, it does not have any numbers on the face bezel, are the numbers anywhere on any of the locks, and do you have to take them out to see them? One of those ebay guys will send you a numbered cut key if I can just get the numbers. I don't have any of the original keys...
Thanks, RickComment
-
Billy Ricks
It's stamped on the bottom of the front edge of the switch. That said, you can buy two blanks for what one cut key cost. I believe the locksmith I went to charged about $1.50 each to cut them. I was going to go the cut route but he didn't have my numbers then I found the guy with blanks.I just noticed on my ignition switch, it does not have any numbers on the face bezel, are the numbers anywhere on any of the locks, and do you have to take them out to see them? One of those ebay guys will send you a numbered cut key if I can just get the numbers. I don't have any of the original keys...
Thanks, RickComment
-
rkj2002
Can I see this without taking the switch out? I found a great guy that will cut it for free I think, if not I can go to my locksmith and he'll do it too.It's stamped on the bottom of the front edge of the switch. That said, you can buy two blanks for what one cut key cost. I believe the locksmith I went to charged about $1.50 each to cut them. I was going to go the cut route but he didn't have my numbers then I found the guy with blanks.
Thanks, BillyComment
-
Billy Ricks
I think you can. With the GSXR gauges I run I can see mine easily. The numbers are right in the middle of the switch, down low on the front side. You'll need a flashlight and maybe even a magnifying glass if you have weak eyes. You may have to pull your gauges to see the number. They'll be just above the headlight.Comment
-
Guest
A guy i knew back in the day had an '83 es too. His key that was a different number than mine would work in mine but my key would not work in his.... I have some old keys here i'd send you if they are the correct number.Comment
-
rkj2002
Thanks Billy, I'll check it out tomorrowI think you can. With the GSXR gauges I run I can see mine easily. The numbers are right in the middle of the switch, down low on the front side. You'll need a flashlight and maybe even a magnifying glass if you have weak eyes. You may have to pull your gauges to see the number. They'll be just above the headlight.
Comment
-
rkj2002
Thank you for the offer, I'll check that number tomorrow
Comment
-
Billy Ricks
Comment
Comment