New Battery and it only turn over breifly before solenoid clicks

Collapse
X
 
  • Time
  • Show
Clear All
new posts
  • Ralpha306

    #1

    New Battery and it only turn over breifly before solenoid clicks

    I pulled my gs from storge and put it in my new garage.. Installed new Battery only to find battery only worked a few seconds be for solenoind clicks... let sit for a few seconds more and it turned over a few more time then died..help
  • Guest

    #2
    Dumb question but did you charge the new battery?

    Comment

    • Guest

      #3
      New batteries need to be charged at a low amp setting for a few hours prior to use, I put mine on a trickle charger at 1 amp for 24 hrs prior to use

      Comment

      • Ralpha306

        #4
        Yeah.. i bought a battery from walmart.. charged for 2.5hrs at 2amps..

        Comment

        • Hoosier Daddy

          #5
          Can you check the specific gravity to verify it is fully charged? You can pic up a cheap tester at any auto parts store. It looks like a small turkey baster but has balls inside that float at different amounts of charge. Count the number of floaters and read the state of charge.
          Last edited by Guest; 03-22-2011, 06:27 PM.

          Comment

          • Ralpha306

            #6
            Thats sounds wild.. i put a mmeter and it reads 12.5 but quickly drops when the engine turns over.. drops until engine doesnt turn over any more

            Comment

            • Hornswaggle

              #7
              was it pre-filled or did you have to add electrolyte?

              Comment

              • Ralpha306

                #8
                i filled it ... waited an hr.... then charged with vent valve open for two and half hours...

                Comment

                • Guest

                  #9
                  Charge it longer you just surface charged it min 10 hrs

                  Comment

                  • Ralpha306

                    #10
                    my charger turned off and the "completely charged" led lit up

                    Comment

                    • Nessism
                      Forum LongTimer
                      GSResource Superstar
                      Past Site Supporter
                      Super Site Supporter
                      • Mar 2006
                      • 35787
                      • Torrance, CA

                      #11
                      2.5 amps is too fast. For a 14 a-h battery you should charge at 1.4 amps max.

                      So assuming the battery is okay, you might want to clean your battery cables - both where they attach to the battery and where they attach at the starter solenoid and ground.
                      Ed

                      To measure is to know.

                      Mikuni O-ring Kits For Sale...https://www.thegsresources.com/_foru...ts#post1703182

                      Top Newbie Mistakes thread...http://www.thegsresources.com/_forum...d.php?t=171846

                      Carb rebuild tutorial...https://gsarchive.bwringer.com/mtsac...d_Tutorial.pdf

                      KZ750E Rebuild Thread...http://www.thegsresources.com/_forum...0-Resurrection

                      Comment

                      • BassCliff

                        #12
                        Hi,

                        If new batteries are not properly initialized you can ruin them. Let's hope that didn't happen. Here's an article: Battery Charging


                        Thank you for your indulgence,

                        BassCliff

                        Comment

                        • Ralpha306

                          #13
                          i went out and bought a new charger.. it charges at 1amp and i charged for 8hr last night.. connected it after work today and nothing same response..
                          1. Did i mess up the battery?
                          2. could it be the starter is having a hard time turning the engine?

                          Comment

                          • Ralpha306

                            #14
                            Just Frustated....Thanks...

                            I Guess i just buy a high dollar battery from somewhere other than walmat and see if that helps the problem.....

                            Comment

                            • Nessism
                              Forum LongTimer
                              GSResource Superstar
                              Past Site Supporter
                              Super Site Supporter
                              • Mar 2006
                              • 35787
                              • Torrance, CA

                              #15
                              Originally posted by Ralpha306
                              I Guess i just buy a high dollar battery from somewhere other than walmat and see if that helps the problem.....
                              Did you clean the cables yet? Did you try to jump the starter solenoid? There are lots of thing to test before jumping to a conclusion.
                              Ed

                              To measure is to know.

                              Mikuni O-ring Kits For Sale...https://www.thegsresources.com/_foru...ts#post1703182

                              Top Newbie Mistakes thread...http://www.thegsresources.com/_forum...d.php?t=171846

                              Carb rebuild tutorial...https://gsarchive.bwringer.com/mtsac...d_Tutorial.pdf

                              KZ750E Rebuild Thread...http://www.thegsresources.com/_forum...0-Resurrection

                              Comment

                              Working...